"Cc leaked from the door after cycle was complete. Ran diagnostics, no codes stored. Ran test cycle, all functions passed. No leaks from door. Checked under unit, found unit is slowly dripping from pump seal. Unit will need pump/motor assembly replaced. ; ordrng 1 W11416362 (Pump/motor)"

"Cc unit not washing dishesRan diagnostics, found code f10e2 for vent wax motor electrical issue. Ran test cycle, it filled but did not wash, pump and motor is running. Found no water in unit. Checked under unit, found water had run out of sump onto floor under unit, found leaking from sump. Unit will need pump/motor replaced. ; ordrng 1 W11416362 (Pump/motor)"

"Cc unit not dispensing water, filter was replaced but unit displays Dispenser OffTried both old and new filters, unit RFID board is not recognizing filter is installed and disables water dispense. Quoted customer RFID filter board replacement. ; ordrng 1 WR55X35905 (RFID water filter board)"

"Cc unit displays F2 and beepsConfirmed unit displays F2 for oven overheat condition. Checked temperature probe resistance, found connector melted and wire burnt. Repaired wiring, checked temperature probe resistance, good at 1074ohms at room temperature. Ran bake test to 350 degrees and monitored to ensure no overheat condition exists. Unit preheats and cycled. Op test good."

"Cc: low ice production, frost build up in ice binFound temps in ff section at 41, freezer at 0. bin 1/4 full. Customer stated ice was emptied at around 8 pm the night before. Advised customer unit can take up to 72 hours for a full bin. Found chute sealing. Cycles ice maker. Ice maker sticking. Needs ice maker.; ordrng 1 W10873791 (icemaker)"