Installed drive belt. Ran dryer test. Unit tumbles and heats. Op test good.

Installed clutch and slider. Ran diagnostics test cycle. Op test ok

"Cc unit still displaying f8e4Plugged in unit and turned water back on. Unit displays f8e4, checked in drip tray, water is present. Emptied tray of water. Pulled unit out and inspected while started a cycle. Found water source connection is now dripping into tray. Connection is already tight. Stopped cycle and turned water off, disconnected water line to inspect. Found elbow connector does not have a rubber gasket. Advised customer she will need a plumber to replace water line."

"Cc unit drum stopped turning Inspected unit , found drum belt snapped. Quoted customer drum belt replacement. ; ordrng 1 WE03X29897 (Belt drive)"

"Cc: door not shutting properly, lower door bentFound door not closing enough to press door switch. Lower door bent, on outside and inside. Found door opening past 90 degrees. Needs inner and outer door panel, and hinges and receivers; ordrng 1 W11385801 (Outer door assembly) and 1 W11334152 (Inner door panel) and 1 W11568941 (Hinge) and 1 W11568813 (Hinge right) and 1 W11317948 (Receiver) and 1 W11318331 (Receiver)"