Cc: not drying properly. Ran timed dry cycle. Found no air flow at outside vent. Pulled unit found a potential kink in vent. Pulled venting. Found vent plugged. Needs vent replaced.

Broken belt. Replaced dryer kit and tested dryer. Everything is working like it should. ; used 1 4392065 (DRYER REPAIR KIT) from stock

"Customer complaint that unit is not getting cold, unit is room temperature, low side is at -20psi, high side is at 80psi, sides did not equalize, unit is restricted , called whirlpool techline spoke to Nate, Nate agrees that unit is restricted but believes that a strong vacuum with a micron gauge would free up restriction, purged system with 250psi of nitrogen, nothing coming through cap tube, called whirlpool techline back spoke to Andrew, unit is non repairable"

"Installed evaporator and filter drier, brought system into a 28 vacuum, watched 15 minutes, no change on gauges, recharged unit with 47g of r600a, good frost pattern, op test good, advised customer to wait 24 hours before restocking refrigerator"

"Customer complaint that unit is not cooling properly, fresh food section temperature is at 51 degrees, freezer section temperature is at 28 degrees, compressor and condenser fan are running, evaporator fan is running, partial frost pattern on evaporator, system has a leak, unit needs new evaporator and filter drier; ordrng 1 W11578004 (Evaporator) and 1 W11504450 (Lokring) and 1 W11506619 (Lokring) and 1 W11109499 (Drier) and 1 W11504445 (Lokring) and 1 W11504447 (Lokring)"