Cc that right hand door gasket is ripping. Confirmed. Replaced gasket and steamed it out for proper seal opt test good.

Cc that unit stopped cooling completely after last visit. Verified and unit was at 70* both sections. Looked in Back of unit and when I touched the drier filter looking for leaks it just came off so unit has been leaking for a while and it was low on freon from the beginning and since I added the freon last visit to see if it was just low or if it was leaking and the solder finally gave out and lost all freon. Discharged unit completely and added new drier filter as best as I could because line was real short already since a sealed system had already been done on unit. Put unit in to a 30vacuum held and charged with 56g of R600a. Recommended customer to wait at least 24hrs for proper cooling.; used 1 W10843121 (DRIER) from stock

"Installed keypad control. Ran test cycle, all functions passed, no faults. Op test good."

Verified temps on unit before doing anything and freezer water at 14* had frost but slightly on bottom. ran kilowatt meter to check the amps on compressor and it was running at about .95amps which is not bad but it seemed like it was low on R600a so BJ recommended me to add some R600 and it was a bit low. Made sure evap had good frost pattern and replaced control board to reset the whole unit and make sure ice maker cycles and fills. Recommended customer to monitor to see if now it starts making ice and cooling properly opt test good.

Cc unit displays f2e1 Confirmed unit is displaying f2e1 for stuck/shorted keyboard. Power cycling unit does not clear fault. Unit will need UI panel replaced. Quoted customer repair cost. ; ordrng 1 WPW10116104 (Switch-memb)