"Cc unit is not spinning out properly and is damaging the front wall, also stated that previous repair company damaged the UI cover when taking it off Found UI cover to be damaged, spun basket by hand found bearings to be extremely loud with just a hand speed spin Also found inner basket where it sits on gear case to be stripped out and has extreme play in basket. Will need basket gearcase, UI cover belt and clutch and nut ; ordrng 1 WH02X10363 (nut hub) and 1 WH45X26739 (basket asm) and 1 WH42X28269 (UI cover) and 1 WH38X27333 (platform trans asm k) and 1 WH05X24185 (clutch) and 1 WH03X32097 (Clutch) and 1 WH01X24180 (drive belt)"

"Cc of error Found error for temp sensor Could not get control to run diagnostics Needs control and temp sensor ; ordrng 1 W10833885 (sensor) and 1 W11258611 (cntrl-elec), used 1 SHIPPING (shipping and handling) from stock"

"Recovered refrigerant Installed compressor evap and die drier Ran 28 inch vac waited 15 min no change Recharged with 3.5 oz r134a Frost pattern showed on evap Advised to let cool for 48 hours ; used 1 WPW10143759 (DRIER), and 1 TJAF1200 (Tube ext) from stock"

Cc of error Could not get UI to respond Customer had a UI sent to her from whirlpool Installed UI Ran auto test and calibration OP Test Ok

Installed damper OP Test Ok