"Cc unit not cooling. Customer wrote notes FZ was working 20*, FF was 60*, changing temp settings had no affect, turned off breaker, now display in FF will not turn on. Not getting voltage from control, nothing to compressor. No voltage to FZ light. No voltage to any fans. Gave estimate for controls, but also let customer know that other components could be affected and more cost even if controls are replaced.; ordrng 1 WR55X10982 (Control) and 1 WR55X10996 (Control), used 1 SHIPPING (SHIPPING LOGISTICS*) from stock"

"Replaced door. Tested dispenser, no leaks. All components working. Good. Op Test Ok."

"Cc scraping noise, maybe belt. Replaced dryer repair kit from t/s. Found scraping from one of the front rollers. Ran unit, tested good. Op Test Ok.; used 1 4392067 (DRYER REPAIR KIT) from stock"

"Cc unit doesnt seem to bring in steam like it should. Power is good, 120vAC, Tested out each motor resistance. Almost spot on where it should be at. All 3 low/med/high settings are working properly. Put up a paper towel to motor and is holding on all 3 settings. Suction is good. As far as functional wise, motor is in specs and working properly. Customer can have the housing venting checked out if needed but the Range Hood is preforming as it should. Op Test Ok. Techline agreed that hood is working as it should. Venting as far as how many 90* elbows and the run length of it can play part. Also mentioned steam can be hard to capture and can also go around hood. Smoke and Grease will be easier to capture."

Replaced knob and timer. Tested. Good and heat cycling. Good. Op Test Ok.